DL-AB 06-200/T-EN54

4 260590 180391

Mounting Instruction

Fasten the speaker ring in the ceiling cut-out by carefully folding the mounting springs. The tensile force of the springs provides a stable hold.
Insert the enclosed rubber grommets into the two holes on the back of the fire dome.
Insert the 100V speaker cables through the grommets of the fire dome.
Attach the fire dome to the speaker ring mounted in the ceiling. To do this, push the three inner springs out of the spring slots towards the centre of the fire dome and then to the side so that they rest against the inside. Position the fire dome in the speaker ring in the ceiling. Please make sure that the fire dome is inserted as far as it will go. Then snap the springs back into the spring slots of the fire dome. This fixes the fire dome in place.
Connect the loudspeaker cable to the ceramic terminal (COM and 100V connection).
Insert the grille into the speaker ring (as far as it will go) and carefully turn the grille clockwise. Use the enclosed mounting hook for this purpose. Do not insert the hook into the grille more than 5mm from the outer ring to avoid damage. The openings of the bayonet catches should be in a straight line with the rivets on the inner side of the speaker ring.

Please note: To avoid damage, we recommend loosening the cable lug with a flat-blade screwdriver when changing the cable to a different power tapping.

Colour	RAL 9010
Dimensions	267x138 mm
Ceiling Cut-out	243 mm
Weight (net)	2,24 kg
Power	2x 6/3/1,5 W
Connector	2-pin ceramic block
Terminal Diameter	3,2 mm
Maximum Cable Passage	8 mm² (single)
Mounting	Snap system