DL 10-165/T plus-EN54
barcode 4 260590 180353

2-way ceiling speaker for Voice Alarm, 10W power, certified EN 54-24

Technical Data
Colour RAL 9010
Dimensions 220x132 mm
Ceiling Cut-out 201 mm
Dispersion -6dB, 500Hz h/v 180°
Dispersion -6dB, 1KHz h/v 155°
Dispersion -6dB, 2KHz h/v 115°
Dispersion -6dB, 4KHz h/v 50°
Sensitivity EN54-24, 1W/1m 86,0 dB
Sensitivity EN54-24, 1W/4m 74,0 dB
Frequency Range 275 - 23.500 Hz
Frequency Response 65 - 24.000 Hz
SPL IEC268-5 , 1W/1m 86,0 dB
SPL EN54-24, Pmax/4m 84,0 dB
Power 10/6/3/1,5 W
DL 10-165/T plus-EN54
barcode 4 260590 180353
Mounting Instruction
  1. Create the necessary ceiling cut-out and check the installation depth.
  2. Fix the outer ring in the ceiling.
  3. Attach the fire dome to the ring in the ceiling.
  4. Lift the three springs on the spring slots on the ring, and turn them to the side. Guide the connection cable through the opening.
  5. Position the fire dome below the notches and then push it upwards. Turn the springs back into the spring slots (starting position).
  6. Connect the loudspeaker cable to the 100V and COM terminals.
    If necessary, select a different power tapping.
  7. Use the enclosed mounting hook to place the grille in the speaker ring and turn it clockwise.

Please note: Do not insert the hook into the grille more than 5mm from the outer ring to avoid damage.

Safety Notice
For this loudspeaker, the retention force of the springs in the mounting frame has been increased to ensure an even more secure hold in the ceiling. Please take this into account during installation to avoid injuries to the hands caused by the stronger springs.
Please do not remove the insulating material from the speaker, as this could have a negative effect on the acoustics.