EN54
DL-E 06-165/T-EN54W
barcode 4 260590 181466

Ceiling speaker for Voice Alarm, power 6W, certified EN 54-24

Technical Data
Colour RAL 9016
Dimensions 199x72 mm
Ceiling Cut-out 166 mm
Dispersion -6dB, 500Hz 180°
Dispersion -6dB, 1KHz 180°
Dispersion -6dB, 2KHz 135°
Dispersion -6dB, 4KHz 60°
Sensitivity EN54-24, 1W/4m 78 dB
Frequency Range 300 - 19.300 Hz
Frequency Response 70 - 23.500 Hz
Power 6/3/1,5 W
EN54
DL-E 06-165/T-EN54W
barcode 4 260590 181466
Mounting Instruction
  1. Create the necessary ceiling cut-out and check the installation depth.
  2. Loosen the nut in the middle of the rear touch guard.
  3. Remove the touch guard of the speaker.
  4. Connect the speaker cable with the WAGO terminals to 100V and COM: select the input with the corresponding power label according to the required power. Push the corresponding lever clamp upwards and insert the cable. Now lower the lever of the terminal again to fix the cable.
  5. Put the touch guard back on the loudspeaker and secure it with the nut.
  6. Fold up the clamping spring and insert the loudspeaker into the ceiling cut-out.
  7. Press the speaker into the ceiling until it is flush with the ceiling cut-out.

Mounting instruction with fire dome FE 165-EN54:

  1. Loosen the nuts and remove the fire dome.
  2. Guide the incoming cable through the cable gland of the fire dome.
  3. Connect the incoming line to the terminal of the loudspeaker.
  4. Replace the fire dome back on the speaker and fasten it with the nut.
  5. Fold up the clamping spring and insert the loudspeaker into the ceiling cut-out.
  6. Press the speaker into the ceiling until it is flush with the ceiling cut-out.